ROOFS & BALCONIES - WARM - EXPOSED - DAMP SUBSTRATES

SPECIFIC SYSTEM FOR WATERPROOFING ROOFS AND BALCONIES WITH A DAMP SUBSTRATE

• Substrate to be treated must be free from debris and dust. Clean the substrate by hydrojet/ high pressure/air blowing or brushing

PRIMERS:

DUROGLASS FU BIANCO TIX, water based 3 component modified epoxy. DPM primer designed for gaining adhesion on humid substrates up to 10 bar of back-pressure.
Solves humidity problems allowing safe application for all kinds of floorings. Overcoating 24 hours at 20° C, 75% RH with a consumption rate is 0,500-0,600 kg/m².
Can be used for scratch coats or roller applications. Low VOC.

DUROGLASS FU RAPID, water based rapid 2 component modified epoxy DPM primer designed for gaining adhesion on humid substrate up to 10 bar of back-pressure.
Solves humidity problems allowing safe application for all kinds of floorings. Rapid curing allowing overcoating within hours even in cold temperatures 4 hours, 6° C, 75% RH.
Can be used for scratch coats or roller applications. Low VOC.
Consumption rate is 0,300-500 kg/m² per coat making sure that areas with greater absorption rate should be treated again.

WATERPOOFING MEMBRANE:

STARFLEX HR, rapid curing pure polyurea two-component 100% solids elas-tomeric, or STARFLEX HR-E, hybrid elastomeric polyurea system formulated with aromatic isocianates and special diammines, free from plastificants and solvents.
STARFLEX HR/HR-E can be apply also in vertical and ceiling.

The products can be applied exclusively by spraying devices (proportional hot spray) with two-component airless pumping units, equipped with a mixing gun.
The necessary equipment must also include pre-heating the separate compo-nents at temperatures of at least 65-75 ° C.
The theoretical consumption is 2,2-4,4 Kg/m².

TOP COAT:

POLISTAR E/P, two component elastic polyurethane based UV- resistant, anti-skid and wear resistant protective coating, one component elastic aliphatic polyurea based top coat for manual application at a rate of 0,15-0,25 kg/m² per coat.
The product for anti-slip can be added /charged with 0,1-0,3 mm quartz and or be broadcasted with 0,1- 0,5 quartz on the first of the 2 top coats.
When 2 coats must be applied do not let more than 48 hours between the coats.

 

POLISTAR E/2, 2k polyurethane based uv- resistant, anti-skid and wear resistant protective coating, with a consumption of 0,150 Kg/m2.

 

• The over coating has to be applied within 3-4 hours maximum after the application of STARFLEX HR-E/STARFLEX HR-S.

• Fast Hardening with a very fast attainment of the final mechanical characteris-tics.
• Applicable also in vertical and ceiling.
• High elasticity, tenacity, resistance to puncturing, abrasion resistance and wear resistance with the ability of crack-bridging.
• Operating temperatures from -40°C to +90° C in the air.

CONTACT US

Consent to treatment*